EXTENDED WALL SLEEVES
|
Extended Wall Sleeves are available for exterior wall thicknesses
greater than 14 1/2" and less than/equal to 30 1/2".
Note: Rear Gas Hook-up is not applicable to Extended Wall
Sleeves.
|
THREE EXTERIOR
GRILLE STYLES OFFER
AESTHETIC OPTIONS
|
Three styles of exterior grilles are available to complement
building aesthetics:
Standard Aluminum Grille
Unpainted grille of stamped, clear anodized aluminum. Protects
the outdoor fan, coil and vent cap assembly.
Designed for optional rear gas hook-up. Available in single
pack or 20 pack.
Architectural Grille-Clear Aluminum
Aluminum-finished, architectural style grille of one-piece
extruded aluminum,
with anodized finish. Designed for optional rear gas hook-up. Available
in single pack.
Architectural Grille-Bronze
Aluminum
Bronze-finished, architectural style grille of one-piece
extruded aluminum,
with anodized finish. Designed for optional rear gas hook-up.
Note:
Standard grilles install from within the building interior.
Important:
Consult manufacturer before using any other exterior grille
or special exterior treatment. Application of non-Suburban
grille or exterior treatment may severely affect the operation
of the Dynaline system, causing hazardous or unsatisfactory
performance.
|
DECORATIVE BASE
CONCEALS
ELECTRICAL AND
GAS CONNECTIONS
|
Non-load bearing, decorative sub-bases are available. The
three dimensional sub-bases span the width of Dynaline's
front cabinet assembly - 42" and extend to a depth of
5".
Specify bases with heights ranging from 4" to 12".
Bases attach to the Dynaline 3 front cabinet assembly, concealing
gas and electrical connections.
|
Leveling Leg Kit
|
Leveling legs (optional; two each) are
available to provide leveling and chassis
support for installations that, because
of wall thickness or chassis projection
into the room, require additional
support. The adjusting screw can be
extended 2", with a maximum distance
from the bottom of wall sleeve to screw
base of 5" and a minimum distance of
3".
|
AIR DISCHARGE PACKAGE
|
The Air Discharge Package allows heating and cooling of an
adjoining room. The basic Air Discharge Package consists
of an Air Discharge Adaptor and Air Discharge Extension.
Installation of the Air Discharge Connector('s)* extends
the run length to a maximum of 130".
* Air Discharge Connectors are not approved for DL3-0912
applications.
The adaptor is preassembled for air discharge to the right
but can easily be converted for discharge to the left.
|
REAR
GAS
HOOK-UP KIT
|
Dynaline 3 chassis are manufactured for front gas hook-up. The
optional rear gas hook-up kit can be used for field conversion
of the chassis to a rear gas hook-up at the RH side (facing back
of unit).
Note:
Rear gas hook-up is not applicable
to extended wall sleeve installations. |
2-PSIG REGULATOR KIT
|
A pounds-to-inches regulator is available for Natural Gas applications.
|
HEAT/COOL WALL THERMOSTAT
|
A low voltage HEAT/COOL wall thermostat kit is available.
Note:
Dynaline 3 chassis are supplied to operate with internal
controls. They are easily converted to function in remote
thermostat applications.
|
