Dynaline 3 Accessories



The capabilities and/or aesthetic presentation of the standard Dynaline 3 system (Chassis, Standard Wall Sleeve & Grille) can be enhanced by application of one or more accessory kits.


EXTENDED WALL SLEEVES

Extended Wall Sleeves are available for exterior wall thicknesses greater than 14 1/2" and less than/equal to 30 1/2".

Note: Rear Gas Hook-up is not applicable to Extended Wall Sleeves.


THREE EXTERIOR
GRILLE STYLES OFFER
AESTHETIC OPTIONS



Three styles of exterior grilles are available to complement
building aesthetics:

Standard Aluminum Grille
Unpainted grille of stamped, clear anodized aluminum. Protects the outdoor fan, coil and vent cap assembly. Designed for optional rear gas hook-up. Available in single pack or 20 pack.

Architectural Grille-Clear Aluminum
Aluminum-finished, architectural style grille of one-piece extruded aluminum, with anodized finish. Designed for optional rear gas hook-up. Available in single pack.

Architectural Grille-Bronze Aluminum
Bronze-finished, architectural style grille of one-piece extruded aluminum, with anodized finish. Designed for optional rear gas hook-up.

Note:
Standard grilles install from within the building interior.

Important:
Consult manufacturer before using any other exterior grille or special exterior treatment. Application of non-Suburban grille or exterior treatment may severely affect the operation of the Dynaline system, causing hazardous or unsatisfactory performance.


DECORATIVE BASE
CONCEALS
ELECTRICAL AND
GAS CONNECTIONS


Non-load bearing, decorative sub-bases are available. The three dimensional sub-bases span the width of Dynaline's front cabinet assembly - 42" and extend to a depth of 5". Specify bases with heights ranging from 4" to 12".

Bases attach to the Dynaline 3 front cabinet assembly, concealing gas and electrical connections.


Leveling Leg Kit


Leveling legs (optional; two each) are available to provide leveling and chassis
support for installations that, because of wall thickness or chassis projection
into the room, require additional support. The adjusting screw can be
extended 2", with a maximum distance from the bottom of wall sleeve to screw
base of 5" and a minimum distance of 3".


AIR DISCHARGE PACKAGE


The Air Discharge Package allows heating and cooling of an adjoining room. The basic Air Discharge Package consists of an Air Discharge Adaptor and Air Discharge Extension. Installation of the Air Discharge Connector('s)* extends the run length to a maximum of 130".

* Air Discharge Connectors are not approved for DL3-0912 applications.

The adaptor is preassembled for air discharge to the right but can easily be converted for discharge to the left.


REAR GAS HOOK-UP KIT

Dynaline 3 chassis are manufactured for front gas hook-up. The optional rear gas hook-up kit can be used for field conversion of the chassis to a rear gas hook-up at the RH side (facing back of unit).

Note:
 Rear gas hook-up is not applicable to extended wall sleeve installations.

2-PSIG REGULATOR KIT


A pounds-to-inches regulator is available for Natural Gas applications.


HEAT/COOL WALL THERMOSTAT


A low voltage HEAT/COOL wall thermostat kit is available.

Note:
Dynaline 3 chassis are supplied to operate with internal controls. They are easily converted to function in remote thermostat applications.